To overview
Fingernail Probe MP-100.04E
Fingernail Probe MP-100.04EFingernail Probe MP-100.04EFingernail Probe MP-100.04E

Fingernail Probe
MP-100.04E

to attach all ∅ 12 mm test fingers and probes according to VDE 0700, part 1, pic. 7
  Hotline for questions: +49 7951 91 50-99 Contact

Additional standards: IEC/EN 60335-1, IEC/EN 60745-1

The fingernail is made of stainless steel. It can be attached to all rigid finger probes and is used for the verification of the sufficient mechanical resistance of parts which are likely to be touched.

On the finger tip, which can be bent to an angle of 90 degree, a grommet for the tensile test is attached.

 

  • Equipment
  • Service

Rigid Finger Probe
MP-P10.15

according to IEC 60950,
section 2.1.1.1
but with a rigid finger probe

Details

Rigid Finger Probe
MP-P10.05

according VDE 0470, part 2, pic. 7, probe 11 resp. IEC/EN 61032

Details

Tension- and Compression Force Meter
MP-P10.34

with linear scale from 0 ... 10 N for precise determination of the tensile and compressive force

Details

Tension- and Compression Force Meter
MP-P10.35

with linear scale from 0 ... 50 N for precise determination of the tensile and compressive force

Details

Rigid Finger Probe with Compression Spring
MP-P10.38

with force scale from 0 ... 50 N in 5 N steps, according VDE 0470, part 2, pic. 7, probe 11 resp. IEC/EN 61032

Details

Rigid Finger Probe with Compression Spring
MP-P10.39

with force scale from 0 ... 100 N in 10 N steps, according VDE 0470, part 2, pic. 7, probe 11 resp. IEC/EN 61032

Details

Tension- and Compression Force Meter
MP-P10.36

with linear scale from 0 ... 100 N for precise determination of the tensile and compressive force

Details

Large storage case
MP-100.13Z

for safe transport and storage of the test probes

Details

DAkkS calibration
MP-100.01Z

according to ISO/IEC 17025

Details

ISO/Factory calibration
MP-100.04Z

according to ISO 9001

Details

Characteristics

Norm:
  • IEC/EN 60335
  • IEC/EN 60745
  • VDE 0700